Hobbico Flyzone Calypso Rx-R Manual de instrucciones

FLZA3000 Mnl v2READ THROUGH THIS MANUAL BEFORE STARTING CONSTRUCTION. IT CONTAINS IMPORTANTINSTRUCTIONS AND WARNINGS CONCERNING THE ASSEMBLY AND USE O

10❏ 6. Connect a 6" [150mm] servo extension wire to the fl ap servo wire.❏ 7. Glue the servo into position as shown in the illustration at step 13

11Flap2nd Hole4th Hole❏ 11. Connect the fl ap pushrod to the servo arm and fl ap control horn as illustrated.❏ 12. Position the servo arm on the servo.

12❏ 2. Insert the wing tube and tighten the screw.❏ 3. Guide the servo wires under the wing tube.❏ 4. Insert the wing into the fuselage as you guide t

13❏ 7. Tighten the screw in the other wing.❏ 8. Connect the aileron and fl ap servo wires to the receiver—a second Y-connector (not included) will be r

14❏ 3. Position the battery where necessary to get the Calypso to balance, or use Great Planes stick-on lead weight.Check the Control ThrowsSame as th

15Aileron Throw Flap ThrowElevator ThrowRudder Throw❏ 3. Note that the throw measurements for the elevator, rudder and fl aps (if used) are taken at th

16Calibrate the ThrottleThis procedure applies only to Tx-R or Rx-R versions of the Calypso, or any other time a transmitter different than the one or

17Charge the LiPo BatteryIf you haven’t yet done so, charge your LiPo battery following the instructions that came with your charger. If uncertain of

18WindThe Calypso is simply hand-launched by advancing the throttle and giving it a gentle toss directly into any prevailing wind—it will basically fl

19ESC TROUBLESHOOTING GUIDETROUBLESHOOTING GUIDEActionProblem ReasonMotor does not work, no tones or beeps are coming from the ESC.The ESC is not rece

2INTRODUCTIONThank you for purchasing the Flyzone Calypso. The Calypso is one of those models that everyone must have because it is stable, gentle and

20Some replacement parts are sold as assemblies (such as the wing). If the servos in your crashed wing (or fuselage) are still functioning you can rem

3If you’re not a member of a club, your local hobby shop has information about clubs in your area whose membership includes experienced pilots. 5. Whi

4Parts may also be ordered directly from Hobby Services by calling (217) 398-0007, or via facsimile at (217) 398-7721, but full retail prices and ship

5ASSEMBLYInstall the Receiver (Rx-R Only)❏ 1. Cut strips from the included, adhesive-backed hook-and-loop material. Stick one to the back of your rece

6❏ 3. Join the stab/fi n assembly to the fuselage, keying the rudder into the hinge.❏ 4. Tighten the assembly to the fuselage with the included bolt an

7ClevisControlHorn3rd Hole4th HoleElevatorRudderNOYESNO❏ 10. With the transmitter and receiver on and the trims centered, connect the clevises to the

8Right RudderUp Elevator❏ 12. Be certain the elevator and rudder respond in the correct directions according to the stick movements on the transmitter

9❏ 3. Use CA to securely glue the fl ap horn to the fl ap.❏ 4. Tie a small nut or other small weight to the end of a 12" [300mm] string.❏ 5. Drop t